|
[Sponsors] |
How to change the boundary type during computation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 20, 2003, 12:10 |
How to change the boundary type during computation
|
#1 |
Guest
Posts: n/a
|
Hi, I want to chang one boundary type into another boundary type during computation automatically by star-cd,for instance,changing the pressure boundary into wall bounary, is there anyone to provide some specific help or suggestion?
thanks a lot! Lee |
|
August 21, 2003, 06:16 |
Re: How to change the boundary type during computa
|
#2 |
Guest
Posts: n/a
|
In transient run, you can use load steps (TRANSIENT panel: GUI - Modules=>transient) to set up: 1. put button Initialize; 2. in load step one, you specify a boundary as pressure, save this load step; 3. then set up load step 2 with boundary as wall, save this load step; 4. Load step range from 1 to 2, apply, write problem file, and you get it.
|
|
November 28, 2003, 21:01 |
Re: How to change the boundary type during computa
|
#3 |
Guest
Posts: n/a
|
you can use the subroutine to change boundary type
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
¿Change boundary condition type? | David | FLUENT | 8 | April 17, 2013 12:35 |
Change boundary type (UDF/journalfile) | Koen | FLUENT | 5 | February 14, 2009 13:04 |
How to change boundary type at calculation time? | Stanislav Kraev | FLUENT | 0 | December 4, 2006 03:33 |
Change Boundary type? | ccc | FLUENT | 6 | January 15, 2004 05:24 |
how to change boundary type in unsteay calculation | cfdfans | FLUENT | 5 | January 9, 2002 08:16 |