 |
 |
 |
|
|
|
[Sponsors] | ||||
October 21, 2003, 06:03
|
non converged solution
|
#1 |
|
Guest
Posts: n/a
|
Hello!
In my modell, long after all the droplets are injected, I get the following warnings: *** WARNING #042 *** PROCESS NOT FULLY CONVERGED -- EQ.,NIT,RESI:TRUE 1 0.30544E-03 *** WARNING #043 *** MINIMUM RESIDUAL AT THE END, RETURNING NON-CONVERGED SOLUTION The calculations don't stop here, but the concentration of the injected ISO-Octan doesn't move on inside the zylinder from the moment the warnings are posted the first time. However the droplets move on through the zylinder. Can anybody help me??? Thanks a lot! Holger |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Solution converged, and then diverge again. | jrg | FLUENT | 2 | April 1, 2013 23:10 |
| solution converged! | Hai Duc | FLUENT | 6 | February 27, 2008 09:17 |
| Calculate a converged flow solution | kumar | FLUENT | 2 | May 24, 2007 01:33 |
| loading new mesh in converged solution | Claudia | FLUENT | 1 | November 4, 2005 05:23 |
| converged solution or correct solution | SAM | FLUENT | 1 | October 12, 2004 15:38 |
Linear Mode
