|
[Sponsors] |
October 19, 2004, 11:54 |
Error: can't read face in model
|
#1 |
Guest
Posts: n/a
|
I have build a simple boolean model in STAR-DESIGN, save it and close the file by NOT SAVE SESSION or SAVE SESSION (have tried both).
Then, when I open the .CCD file next time, sometimes (in most cases) the following series of error messages appear: face: xxx read from image file, but not in mode and all solid model was lost, but all items in the PROBLEM DEFINITION tab remain. What is the cause of the problem and how to eliminate this? |
|
October 21, 2004, 09:47 |
Re: Error: can't read face in model
|
#2 |
Guest
Posts: n/a
|
The problem appears when I use LINEAR PATTHERN to create a flow domain by Boolean subtraction.
When I delete the linear pattern and create all the obstacles one by one. It is OK. Is there any tricks or tips in using the LINEAR PATTERN and CIRCULAR PATTERN? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fluent Read Error | Joe | FLUENT | 4 | September 23, 2008 22:16 |
Read cloud of points and interpolate on face centers | bramdejager | OpenFOAM Pre-Processing | 2 | September 5, 2007 06:13 |
[Commercial meshers] FluentMeshToFoam Error A model face is not matched Shape detection failed | vvqf | OpenFOAM Meshing & Mesh Conversion | 2 | June 1, 2006 08:06 |
Read error | sampaio | OpenFOAM Running, Solving & CFD | 8 | April 19, 2006 09:44 |
Read/Write error | Alec Eiffel | FLUENT | 6 | June 8, 2005 02:53 |