 |
 |
 |
|
|
|
[Sponsors] | ||||
February 18, 2005, 03:14
|
help required
|
#1 |
|
Guest
Posts: n/a
|
hello
i have four inlet manifold exhaust system,i have to do analysis in starcd by changing the inlet as per the valve timings. can I change the inlet boundary in certain time interval how can i proceed with this problem thanx in advance bye Rajesh |
|
|
||
|
February 18, 2005, 04:15
|
Re: help required
|
#2 |
|
Guest
Posts: n/a
|
You can make the inlet conditions a function of time by using a table or a user subroutine. You can even change an inlet into a wall if you want to, though this can only be done with load steps (advanced transients).
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help required! | Adi | FLUENT | 1 | May 20, 2008 00:58 |
| Help Required | Renuka | FLUENT | 3 | May 8, 2008 00:14 |
| Help Required......... | vijayaragavan | FLUENT | 5 | February 14, 2008 03:01 |
| paper required | d.kumar | Main CFD Forum | 0 | February 9, 2007 01:01 |
| Help required...udf | derick | FLUENT | 0 | September 15, 2005 16:46 |
Linear Mode
