Moving Mesh with NEWXYZ
I'm using subroutine NEWXYZ.F to move mesh, but i could not set the correct moving event. how to do it?
thanks very much! |
Re: Moving Mesh with NEWXYZ
Linking pmov executable...
FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME gps2d GEOMETRY FILE TITLE *** ERROR *** MAX PROSTAR CELL NUMBER EXCEEDS 1 RELINK pmov AFTER UPDATING THE PARAMETER FILE How to make it correct? thanks. |
Re: Moving Mesh with NEWXYZ
I use the following codes in prostar:
time trans mvgrid on geom,XXX prob,XXX then in terminal, pmovlink Are you running a local Prostar version? Please enter y or n [n] Please enter the required Prostar driver: Available drivers are: x xm glm [x] Linking pmov executable... FORTRAN 77 Compiler 7.5, Copyright (c) 1987-2001, Absoft Corp. ENTER CASE NAME gps2d GEOMETRY FILE TITLE *** ERROR *** MAX PROSTAR CELL NUMBER EXCEEDS 1 RELINK pmov AFTER UPDATING THE PARAMETER FILE HOW TO make it correct? thanks |
All times are GMT -4. The time now is 12:38. |