 |
 |
 |
|
|
|
[Sponsors] | ||||
May 9, 2005, 07:11
|
Modelling in EZ-Turbo
|
#1 |
|
Guest
Posts: n/a
|
I've got several problems preparing surfaces in ez-turbo! If somebody deals with radial machines, please write about error "MORE THAN ONE CONTINUOUS BLADE CROSS-SECTION FOUND" which occurs at generating streamlines! The blade is twisted!
Thanks! |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| G/Turbo | nathan | FLUENT | 1 | April 27, 2007 19:19 |
| G/Turbo | Jack | FLUENT | 1 | January 15, 2007 14:06 |
| G turbo | bharat | FLUENT | 0 | September 7, 2005 20:12 |
| about EZ turbo | mohr76 | Siemens | 0 | July 26, 2004 09:18 |
| about EZ-Turbo | Ling-Chia | Siemens | 1 | December 22, 2002 23:30 |
Linear Mode
