can't run moving mesh

May 29, 2005, 05:18

when i run tut11-1 or tut13-1,i find the error message:PNP: ***ERROR*** No response from HOST "lxh" or invalid hostname. PNP: ==> Please check that you are specifying your nodes correctly. any one can tell me how to solve the problem,thanks!

May 29, 2005, 12:31

You are already using StarCD v3.20 - v3.24. This error message has nothing to do with the model setup anyway.

Check the hardware.ini in /usr/starcd/etc. It seems to be that there are some settings are not correct about the computers to use for this case, or that you possible have a network problem (means when "lxh" is your remote server for the calculation, and not you local workstation).

May 29, 2005, 05:18	can't run moving mesh	#1
roger Guest Posts: n/a	when i run tut11-1 or tut13-1,i find the error message:PNP: *ERROR* No response from HOST "lxh" or invalid hostname. PNP: ==> Please check that you are specifying your nodes correctly. any one can tell me how to solve the problem,thanks!

May 29, 2005, 12:31	Re: can't run moving mesh	#2
Hubert Janocha Guest Posts: n/a	You are already using StarCD v3.20 - v3.24. This error message has nothing to do with the model setup anyway. Check the hardware.ini in /usr/starcd/etc. It seems to be that there are some settings are not correct about the computers to use for this case, or that you possible have a network problem (means when "lxh" is your remote server for the calculation, and not you local workstation).

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Moving Reference frame - UDF - Moving mesh	modisa	FLUENT	0	April 18, 2008 13:31
Moving Mesh & Not Rotating Mesh	AB	Siemens	1	October 25, 2004 03:10
moving mesh	Jim	Siemens	2	August 27, 2002 07:39
moving mesh	zqf	Siemens	1	June 19, 2002 01:30
moving mesh	khb	Main CFD Forum	1	June 5, 2002 10:46