Home > Forums > Software User Forums > Siemens

parallel configure problem

Mark Forums Read

Reply

Search this Thread

August 13, 2005, 06:21	parallel configure problem	#1
ben Guest Posts: n/a	I have installed starcd for windows 3.22 on several computer and have used Mpiregister.exe for registering user name and pass (same for all computers) , but when running solver in parallel mode these errors have been shown : -tracker task on host1 host2 for monitoring host and process failure. (it shows in serial mode too but not stop processing) -c:\windows\system32\ rem " Process 0 on host1 host2 exited without calling mpi finalize ...., aborted by user request Can anyone tell me, how can i correct configure Mpich for solving this problem ? Regards

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Parallel UDF problem	Lindsay	FLUENT	4	June 20, 2016 10:37
Parallel UDF Problem	Dimitris	Fluent UDF and Scheme Programming	7	September 20, 2013 02:51
Problem in Parallel UDF	Giacomo de Renzi	FLUENT	12	June 18, 2008 13:19
parallel UDF problem	kerem	FLUENT	2	June 20, 2006 07:56
HOW TO CONFIGURE GAMBIT 2.0 WITH EXCEED 9.0	adlane	FLUENT	0	February 15, 2004 08:41

All times are GMT -4. The time now is 18:28.