 |
 |
 |
|
|
|
[Sponsors] | ||||
*** ERROR #320 *** INCORRECT WALL HEAT BOUNDARY... |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 9, 2005, 08:19
|
*** ERROR #320 *** INCORRECT WALL HEAT BOUNDARY...
|
#1 |
|
Guest
Posts: n/a
|
Dear All,
My model has two fluids and one solid. I made all interfaces between the fliuds and solid as conducting wall.There is no interface between the two fluids. when i checked the model it gives no error but when i give the run, it gives the following error. *** ERROR #320 *** INCORRECT WALL HEAT BOUNDARY SPEC AT PHYSICAL BOUNDARY Anybody has idea about what is causing this error? Please help me. BV |
|
|
||
|
September 11, 2005, 18:26
|
Re: *** ERROR #320 *** INCORRECT WALL HEAT BOUNDAR
|
#2 |
|
Guest
Posts: n/a
|
did you switch on conjugate heat transfer?
|
|
|
|
||
|
September 12, 2005, 04:09
|
Re: *** ERROR #320 *** INCORRECT WALL HEAT BOUNDAR
|
#3 |
|
Guest
Posts: n/a
|
Yes, I have swithched on the Conjugate Heat Transfer.
Any other reason which is causing this problem?? BV |
|
|
|
||
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error Orient Face incorrect | MK | Siemens | 5 | January 19, 2009 09:46 |
| Incorrect wall function BC info in User Guide | schoon | OpenFOAM Bugs | 0 | October 23, 2008 11:35 |
| Wall boundary condition (heat transfer) | Arnold | FLUENT | 4 | February 16, 2006 23:35 |
| Heat Transfer & Boundary Conditions across 2D wall | SAAD | Main CFD Forum | 6 | March 13, 2005 13:42 |
| wall heat boundary | Marco | Siemens | 5 | September 9, 2004 10:50 |
Linear Mode
