 |
 |
 |
|
|
|
[Sponsors] | ||||
October 31, 2005, 19:11
|
Error about open x display
|
#1 |
|
Guest
Posts: n/a
|
I have changed the installation from SCO xvision to Exceed, but it still shows the same error on screen. What should I do?
|
|
|
||
|
December 5, 2005, 13:48
|
Re: Error about open x display
|
#2 |
|
Guest
Posts: n/a
|
What kind of computer are you running and what operating system. I tried to run prostar on a laptop with an onboard graphics card (Windows XP) and got the same error. I did some research and found that there is some problem where the software does not have the required code to run through a shell like xvision AND onboard graphics cards.
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| error x display | Phil | Siemens | 2 | January 3, 2007 17:21 |
| Unable to open display | Alan | FLUENT | 5 | January 10, 2006 12:24 |
| display error | davis | FLUENT | 1 | February 2, 2005 01:53 |
| Error attempting to open X display | pradeep PANTANGI | Siemens | 5 | September 14, 2004 14:25 |
| DISPLAY ERROR!! | Alex | FLUENT | 4 | February 12, 2004 09:40 |
Linear Mode
