 |
 |
 |
|
|
|
[Sponsors] | ||||
November 9, 2005, 04:35
|
cell removal
|
#1 |
|
Guest
Posts: n/a
|
Hi,
I am simulating a problem with cell removal. What BCs should be given at interface? Unfortunately I have coupling there. Shall I remove coupling and use attach BC? I have done creating the events like this. If I see the mesh removal animation, it looks fine. But when I give run the cells are getting removed (deactivated) and the next cell layer is expanding upto the first cell. This is not desirable and it is increasing the cell aspect ratio to very high value. |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| add/removal of grid lines | George | Main CFD Forum | 21 | July 27, 2006 18:38 |
| Mass removal and injection...Please help! | Kevin Till | Siemens | 27 | July 25, 2005 13:09 |
| Mass removal and injection | Kevin Till | Siemens | 6 | July 1, 2005 09:04 |
| vaporization and Material removal | m.sundar | FLUENT | 3 | May 10, 2005 01:10 |
| Cell-vertex and cell-centered finite volume method | Praveen | Main CFD Forum | 4 | September 8, 2003 23:58 |
Linear Mode
