CFD Online Discussion Forums

CFD Online Discussion Forums (
-   Siemens (
-   -   mass flow rate (

Dr C.Bhasker November 28, 2005 06:13

mass flow rate
Star-CD users!

I have recently solved a problem of complex duct with multiple outlets in Fluent/CFX/Star-CD under identical flow conditions and obtained the convergence of numerical solution in all the solvers. I am very much impressed about flow pattern captured at mid-section of the duct in star-CD over other solvers. In other solvers, I could able to obtain mass flow rates at different outlets by mouse click. I am unable to find the same in star-CD. Can any one suggest a way as how to obtain mass flow rate at different outlets through single command. Towards this I am spending quite lot of time in Star-CD.

Dr C.Bhasker

John Luo November 28, 2005 08:03

Re: mass flow rate
I know one way: in PROSTAR, Analysis Control=>Output Controls=>Monitor Numeric Behavior Click Print Iteration Residuals and Conservation Checks, then re-write problem file and run RESTART for one iteration, you can have all the information in .info file.

Ben November 28, 2005 12:36

Re: mass flow rate
go to analysis controls -> Output controls -> monitor engineering behaviour -> monitor boundary behaviour ....

Dr C.Bhasker November 29, 2005 02:34

Re: mass flow rate
Thanks! it has provided the required information in info file.

Dr C.Bhasker

Dr C.Bhasker November 29, 2005 02:36

Re: mass flow rate
The hint povided by you works fine and with this required information is available in inf file after its run.

Dr C.Bhasker

Hubert Janocha December 20, 2005 05:08

Re: mass flow rate
with "monitoring boundary behaviour" an *.erd will be created with the selected boundary information (e.g. massflow)

With "monitoring cell behaviour" you can get the selected information in any wanted (and previously defined/stored) cell set in the *.ecd file.

In main menu "Post" use the "flux summ" command (read help)

Load *.pst file, get "Mass Flux" from vector data, generate a cell set and type in the command "summ".

All times are GMT -4. The time now is 17:03.