how to get cell face area and U in registers
 

Hi, everyone:

In a pipe flow, I want to get the U component of velocity and the cell face area of the layer cells, I have try to use inte command, but the result is not right. Are there any other ways to get the U multiply Area of the cells and load them in registers.

Re: how to get cell face area and U in registers
 

load the result data plot the cells and then type these commands in input window 1)getc u none 2)oper getc area 4 3)oper mult 1 4 5 you will get area * Uvel data in register 5.

Re: how to get cell face area and U in registers
 

( oprer getc area 4 )can only load shell or baffle area, this comand can not load cell area, so value in register is zero.

Re: how to get cell face area and U in registers
 

Put shells on the faces that you want areas for.