|
[Sponsors] |
May 19, 2006, 07:43 |
Initialization
|
#1 |
Guest
Posts: n/a
|
Hello everybody,
Thermophysical models and properties > liquids and gases > Initialization; for this panel the only option available is manual initialization for my model. Why code initialization is not possible? on this panel there are two tabs-flow conditions and turbulence. Do I need to specify velocity,pressure,temp.,estimated Max velocity and turbulence in this panel considering my run is initial,i.e. not a restart. As per my understanding this values specify condition of cylinder before starting piston motion. Please correct me if I am wrong. Please Please Please help. Thanking you. |
|
May 19, 2006, 09:03 |
Re: Initialization
|
#2 |
Guest
Posts: n/a
|
For transient run, like boundary condition, user has to provide initial condition. Initialisation by the code only applies to steady flow. The velocity, temperature etc specified by you will be used as the starting condition
|
|
May 19, 2006, 13:55 |
Re: Initialization
|
#3 |
Guest
Posts: n/a
|
Hello John,
Thank you very much once again. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
initialization | kunal | FLUENT | 5 | April 17, 2008 23:45 |
Initialization - VOF | moas | FLUENT | 4 | February 19, 2008 23:35 |
DPM Initialization | Johannes | FLUENT | 1 | June 20, 2007 10:27 |
initialization | alfa | FLUENT | 0 | March 19, 2006 11:26 |
Initialization of VOF | Jennie | Main CFD Forum | 4 | November 18, 1999 17:41 |