|
[Sponsors] |
May 30, 2006, 02:35 |
.pstc format
|
#1 |
Guest
Posts: n/a
|
I converted the date .pstc from .pst on prostar. and I want to know the format of .pstc
Could you help me to know the format of .pstc please? Maki |
|
May 30, 2006, 12:00 |
Re: .pstc format
|
#2 |
Guest
Posts: n/a
|
.pst is binary and .pstc is coded. is that what you want to know?
|
|
May 30, 2006, 21:31 |
Re: .pstc format
|
#3 |
Guest
Posts: n/a
|
I want to know the format of .pstc especially about the meaning of the data. I want to know temparature of some cells from .pstc and I found the temparature data in it. but I dont know how to know which data is the right data I need.
could you tell how to know about the data? |
|
May 30, 2006, 21:37 |
Re: .pstc format
|
#4 |
Guest
Posts: n/a
|
use monitor engineering data tab for those cells and finally check values you want in .ecd file.
|
|
May 31, 2006, 05:21 |
Re: .pstc format
|
#5 |
Guest
Posts: n/a
|
It is better to use the "saveu" command for thet purpose.
|
|
June 2, 2006, 00:43 |
Re: .pstc format
|
#6 |
Guest
Posts: n/a
|
Thank you for the replies. I'll try both of them.
Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
msh format | Frank | FLUENT | 1 | June 27, 2012 10:39 |
The format of add new BC | ivanyao | OpenFOAM Pre-Processing | 0 | November 13, 2008 21:30 |
About the *.neu file format ! | dongliang | FLUENT | 0 | October 24, 2008 04:50 |
help!!! 3ds format to DXF | Pin | Main CFD Forum | 0 | September 3, 2006 20:38 |
AFLR3 format | rooh | Main CFD Forum | 0 | June 20, 2006 17:07 |