|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi. I am modling flow and H.T. in helical pipe. I am trying to calculate the heat transfer coefficient using the adapco-online Dr. Post help (HCOEF using fluid bulk temperature). Dr. Post uses the SW velocity in calciulating the bulk temperature. It works well in my straight pipe model. However, it gives negative values in case of helical pipe. I tried the ABSO oper as the velocity (I use SU) in helical pipe +ve and -ve in the general Cartisian Cooridenates, but it did not work , HCOEF is -ve, too. Please help. Thanks. W.A.
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Urgent, Urgent, a UDF problem, PLEASE HELP!!! | Max | FLUENT | 1 | September 24, 2010 20:30 |
plz help its urgent | garima chaudhary | FLUENT | 0 | September 25, 2007 05:28 |
need urgent help please! | shirrant | FLUENT | 0 | September 25, 2007 03:35 |
need paper very urgent humanity,very urgent,urgent | mohamed | FLUENT | 0 | August 9, 2006 11:40 |
tmerge urgent urgent | jessica | FLUENT | 4 | July 15, 2006 13:37 |