 |
 |
 |
|
|
|
[Sponsors] | ||||
July 7, 2006, 09:00
|
Hybrid mesh generation
|
#1 |
|
Guest
Posts: n/a
|
I am currently modelling a car body in a drying room with pro-amm. After the successful generation of the subsurface i wanted to create a Hybrid mesh (tetra and hexahedral cells) between the outer area of the subsurface and the domainīs outer area.
I got the following error message for the hybrid mesh generation : Recovering the surface... boundary segment can not be recovered the two points of this segment are: x1 y1 z1 and x2 y2 z2 please use the normal meshing process.. i get to this place and modified the elements but then i got the same message for another place, and so on.. Any ideas? Thanks, Fred. |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hybrid Mesh | Marc | FLUENT | 4 | July 18, 2007 21:38 |
| Hybrid mesh generation | Jake | Main CFD Forum | 2 | April 21, 2007 15:27 |
| when i must use the hybrid mesh ? | mike | FLUENT | 1 | August 25, 2006 12:16 |
| hybrid mesh | Fabrizio | FLUENT | 4 | August 16, 2006 07:41 |
| Guideline for hybrid mesh generation | Sven Schmid | Main CFD Forum | 4 | January 16, 2006 03:20 |
Linear Mode
