|
[Sponsors] |
December 3, 2006, 05:22 |
How could I build symmetrical mesh?
|
#1 |
Guest
Posts: n/a
|
I had some trouble. I used pro-modeler to creat the mesh. The model is a sphere in a rectangular. http://www.wretch.cc/album/show.php?...1304924795&p=0 I want to build mesh is symmetrical in right hand side and left side in the sphere. How could I build the symmetrical mesh? (I try to use STAR-CD to use symmetrical boundary condition in the half of the model, but it is not convergence. Because the symmetrical boundary condition must not have a gradient, I am so confused.)
THX |
|
December 9, 2006, 03:47 |
Re: How could I build symmetrical mesh?
|
#2 |
Guest
Posts: n/a
|
to do that just build the grid for half of the domain then use the star-cd command cvreflect. that will creat an indentical mesh on the second side.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Symmetrical Model With Non Symmetrical Solution | jason | OpenFOAM Running, Solving & CFD | 25 | December 18, 2007 02:49 |
How to build dynamic mesh? | arwang | FLUENT | 2 | March 7, 2007 09:19 |
BUILD MESH: CFX4 | RK | CFX | 0 | June 25, 2005 06:12 |
How to build the mesh | Lee | Siemens | 4 | October 26, 2004 05:29 |
CFX 5.6 mesh build | shhe | CFX | 1 | February 13, 2004 04:27 |