increasing cell size in STAR-CCM+
Hi
Does anyone know if and how it is possible to have an increasing cell size in one region. An example could be a pipe where the cell size grows further downstream.. If this isnt possible, can you then think of any alternatives? Best regards Kasper Skriver FLSAirtech - Denmark |
Re: increasing cell size in STAR-CCM+
You can adjust the surface mesh sizes on the individual boundary regions. This would affect the volume mesh size. You also might consider a volume source to increase or decrease the cell size and cell count. (See the help on volume sources, volume shapes.)
|
Re: increasing cell size in STAR-CCM+
Thanks,
I have done it by the volume source method which is actually quite good. Consulting CD-Adapco gave me the same answer.. |
All times are GMT -4. The time now is 04:33. |