Prism layer in Starccm+

January 17, 2007, 15:28

In my mesh I have some very small features I am interested in. For example, one part is a fuel nozzle recessed into a vane. Part of the fuel nozzle is in to flow and the other part is mostly out of the flow. This leads to part of the nozzle having high wall y+ values and the other part having low y+ values.

Is there some way to vary the prism layer thickness over the nozzle the complete nozzle has good y+ values?

January 19, 2007, 05:12

I think you should split the boundary in two or more seperate boundaries. You can then individually specify prism thickness and amount of layers.

BR Kasper

January 17, 2007, 15:28	Prism layer in Starccm+	#1
Josh Guest Posts: n/a	In my mesh I have some very small features I am interested in. For example, one part is a fuel nozzle recessed into a vane. Part of the fuel nozzle is in to flow and the other part is mostly out of the flow. This leads to part of the nozzle having high wall y+ values and the other part having low y+ values. Is there some way to vary the prism layer thickness over the nozzle the complete nozzle has good y+ values?

January 19, 2007, 05:12	Re: Prism layer in Starccm+	#2
Kasper Skriver Guest Posts: n/a	I think you should split the boundary in two or more seperate boundaries. You can then individually specify prism thickness and amount of layers. BR Kasper

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problem in prism layer generation	shrimp	CFX	5	March 26, 2010 12:34
Prism Layer in STAR-CCM+	Antimony	Siemens	11	July 2, 2009 06:26
[Commercial meshers] TGridFluent mesh with internal by prism layer and internal face for diagnostic	sponiar	OpenFOAM Meshing & Mesh Conversion	2	March 30, 2009 15:02
Prism layer	Francesco - University of Florence, Italy	CFX	8	May 3, 2008 16:42
problem in convergence with the prism layer genera	rakesh	CFX	3	September 18, 2006 10:13