|
[Sponsors] |
January 22, 2007, 09:13 |
question about sco x vision
|
#1 |
Guest
Posts: n/a
|
Hello to everybody,
I have a question about the SCO Xvision program. After the installation of the program I try to open prostar and appears a warning message error in opening X display. Do anyone know what maybe the problem is? I have read the frequently asked questions paper and I did not manage to deal again with this problem. Do you know another alternative program? Thank you in advance. George. |
|
January 22, 2007, 09:47 |
Re: question about sco x vision
|
#2 |
Guest
Posts: n/a
|
After installing STAR-CD and X-Vision, you have to go in the Control Panel, then : Vision Comunications >Transports >TCP-Unix: Properties and you set ENABLE this transport. Restart X-vision and start prostar.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DPM question | Richardson | FLUENT | 10 | December 4, 2007 09:44 |
Yet another UDF question. | Bee | FLUENT | 0 | October 9, 2006 03:46 |
C question | shuo | OpenFOAM Running, Solving & CFD | 0 | September 30, 2006 18:56 |
problem with SCO X-Vision | Prabodh | Siemens | 11 | October 24, 2004 07:26 |