|
[Sponsors] |
February 23, 2007, 07:36 |
EBU problems
|
#1 |
Guest
Posts: n/a
|
Hello, I am trying to simulate a steady state ethylene-air flame inside a tube. I am using the standard ebu model. I seem to get converged solutions. However, the maximum temperature occuring in the domain is always equal to the artificially set temperature limit. Even if I set this much higher than the expected flame temperature. I am using the built in values for heats of formation. For the temperature calculations i use static enthalpy and the "thermal" option. Does anyone have any susggestions as to what i might be doing wrong? Thanks, Thomas
|
|
February 23, 2007, 15:44 |
Re: EBU problems
|
#2 |
Guest
Posts: n/a
|
you are using EBU, what do you exoect?
the best model is COMTIME and COMRATE. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF problems | Winnie | FLUENT | 22 | February 29, 2020 04:32 |
Problems with Fluent on simple 1D problems | agg | FLUENT | 3 | November 21, 2008 11:55 |
problems | Rogerio Fernandes Brito | CFX | 1 | May 5, 2008 21:08 |
MPI PROBLEMS | gtg627e | OpenFOAM Running, Solving & CFD | 20 | October 5, 2007 04:02 |
UDF problems | Paolo Lampitella | FLUENT | 5 | September 8, 2005 20:43 |