CFD Online Discussion Forums

CFD Online Discussion Forums (
-   Siemens (
-   -   Meshing in Pro-Star (

usker April 4, 2007 06:13

Meshing in Pro-Star
Hello everybody! I am doing analysis on Roller Vane Pump. The size of the gap between the vane and the stator in the most narrow region is 0.05mm. Do you think it is possible to create mesh that small in pro-star or pro-amm?

Thanks a lot

Balduin Bankerotti April 4, 2007 16:01

Re: Meshing in Pro-Star
Where should be the problem?

All times are GMT -4. The time now is 21:37.