Home > Forums > Software User Forums > Siemens

no temperature at monitoring location

Mark Forums Read

Reply

Search this Thread

April 22, 2007, 04:09	no temperature at monitoring location	#1
sijin james Guest Posts: n/a	I m doing a moving mesh problem and when the iterations crossed 180(360 DCA) every parameters at monitoring locations dips to Zero suddenly except pressure.. Y its so?? its happened at the end of compression sroke n starting point of expansion.. i m doing amovin mesh analysis in diesel engine using STAR CD.. please give a solution.. thank u..

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Maximum temperature at each axial location	Eric	FLUENT	0	March 14, 2009 06:30
Average Temperature vs. Location, Star-CCM+	new2CFD	Siemens	6	March 13, 2008 14:57
What is Monitoring cell?	Tipakorn	Siemens	2	March 28, 2006 20:38
CPU Monitoring	Bob	FLUENT	2	June 2, 2004 18:51
monitoring	neil	FLUENT	1	March 3, 2003 23:35

All times are GMT -4. The time now is 13:33.