|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Dear guys,
I am running a STEADY STATE problem of conjugate heat transfer with heat source in solid region. It is a problem of 11 lack cells.after 3000 iterations, mass residual is fluctuating about 4.3e-3(very less fluctuation) all velocity residuals of the order of 3.0e-6. Enthalpy residual for solid fluctuating about 2.6e2. all settings by default(SIMPLE ALGO)all underrelaxation parameters by default. How to further reduce the residuals. any suggestions urgently needed... thanksin advance |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
have you under-relaxed for solid as well ??
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
NO
|
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
NO nO underrealxed
|
|
![]() |
![]() |
![]() |
#5 |
Guest
Posts: n/a
|
try to use an under-relaxation factor of 0.999 for solids. U set this parameter in the thermal option panel. if it doesn't work U have to perform a transient analisys.
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
URF and convergence in natural convergence | Marie-Anne | Main CFD Forum | 11 | September 11, 2009 10:07 |
convergence | vijay | FLUENT | 6 | February 1, 2006 03:04 |
convergence | vijay | Main CFD Forum | 1 | January 30, 2006 13:13 |
too bad convergence | Davoche | Main CFD Forum | 2 | November 20, 2005 05:08 |
About convergence | LQ | CFX | 3 | June 2, 2005 23:43 |