 |
 |
 |
|
|
|
[Sponsors] | ||||
June 6, 2007, 22:11
|
mesh preview mode
|
#1 |
|
Guest
Posts: n/a
|
where can we find the mesh preview mode setting ? I read a book which talk about the noving mesh , in one of example in this book . It asked me set rconstant , but I can not find this setting.
|
|
|
||
|
June 15, 2007, 16:36
|
Re: mesh preview mode
|
#2 |
|
Guest
Posts: n/a
|
Try turning switch 4 on in pro-STAR before you start the simulation.
|
|
|
|
||
|
June 16, 2007, 05:10
|
Re: mesh preview mode
|
#3 |
|
Guest
Posts: n/a
|
Actually it should be real constant 4, not switch. The activation command is RCONST 4,1
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] Preview mesh in Paraview | gareth__it_power | OpenFOAM Meshing & Mesh Conversion | 8 | June 4, 2011 12:13 |
| Help with Mesh motion preview | Mustafa Ayad | FLUENT | 2 | January 20, 2009 22:40 |
| Cannot preview the dynamic mesh | sam | FLUENT | 4 | May 26, 2005 06:58 |
| Cannot preview mesh motion! | dvinh | FLUENT | 0 | August 17, 2004 23:44 |
| about preview mesh motion | lingo | FLUENT | 1 | July 8, 2004 12:13 |
Linear Mode
