'No response from HOST' error-Moving mesh problems

June 15, 2007, 00:15

Invoking the 'star' command to solve any moving mesh models in my standalone Compaq Windows XP system results in the following error: PNP: ***ERROR*** No response from HOST "<hostname>" or invalid hostname PNP: ==> Please check that you are specifying your nodes correctly. Does this have to do with Firewall settings, or entities in the hardware.ini file? A solution/suggestion to this is appreciated.

Alfred Herman

June 15, 2007, 06:53

hi alfred

are you using authorized licenses ?? .. if so contact suuport team in your country

kia

June 15, 2007, 00:15	'No response from HOST' error-Moving mesh problems	#1
Alfred Herman Guest Posts: n/a	Invoking the 'star' command to solve any moving mesh models in my standalone Compaq Windows XP system results in the following error: PNP: *ERROR* No response from HOST "<hostname>" or invalid hostname PNP: ==> Please check that you are specifying your nodes correctly. Does this have to do with Firewall settings, or entities in the hardware.ini file? A solution/suggestion to this is appreciated. Alfred Herman

June 15, 2007, 06:53	Re: 'No response from HOST' error-Moving mesh prob	#2
kia Guest Posts: n/a	hi alfred are you using authorized licenses ?? .. if so contact suuport team in your country kia

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
in fluent i get system error : host not found	rok	FLUENT	2	October 1, 2007 00:03
Error in moving mesh	Somnath	Siemens	2	January 20, 2005 10:49
Error in moving mesh	sasikumar	Siemens	0	January 10, 2005 06:44
moving mesh error.	dorain	Siemens	0	December 7, 2004 00:50
Problems with moving mesh	Valery Ponyavin	Siemens	2	January 28, 2003 22:48