 |
 |
 |
|
|
|
[Sponsors] | ||||
September 21, 2007, 03:37
|
AMG troubles - help?
|
#1 |
|
Guest
Posts: n/a
|
I started a parallel calculation with AMG. After 60 iterations the job is killed. Error message is following:
Process 1 amg_error: amg_trunc : error (1) occurred ierr_amg= 2981 Please contact CD-adapco support. STAR MPI_ABORT executed from processor 1 For an another mesh (same geometry ans settings) the job run until convergence. What is the problem? Thanks for your help. |
|
|
||
|
September 22, 2007, 14:03
|
Re: AMG troubles - help?
|
#2 |
|
Guest
Posts: n/a
|
try CG algorithm. If it works, it means the AMG solver diverges.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Troubles with the dpm model | Marco Antonelli | FLUENT | 10 | December 7, 2010 09:18 |
| setup troubles | maxim | FloEFD, FloWorks & FloTHERM | 0 | March 4, 2009 09:46 |
| UDF troubles | Rachel | FLUENT | 1 | June 29, 2008 23:02 |
| 3d VOF troubles... | Mac | FLUENT | 0 | March 12, 2007 08:41 |
| some video troubles... | giosue | Siemens | 2 | February 19, 2003 10:03 |
Linear Mode
