Hi everybody..

Now i am studing on fuel cells and i need es-sofc tutorials and using guides. if anybody has any materials about these please share it with me..

i only try to solve the problem in es-sofc with default values, but i failed in first time.. without using guide and tutorials it likes impossible to get any accurate results.. and to learn

thanks a lot already..

Since you have tried to use the software you obviously have a license. CD-adapco products usually include the user guide as a pdf file. It is possible that the user guide is missing from es.sofc and supplied at the end of the training course.

Is there any reason why you are not taking the training course with this software? The tutorials you talk about are probably part of the training course. In this case the tutorials will not be issued. All training material remains internal to the company.

adapco has the documents you want so why not ask?

RSVP

Thanks Peter for your advise..

I will ask for tutorials to cd-adapco and they will redirect me to local agent where i am.. (if there are not any agent in my country what they will do?) and i know there are not any tutorials about essofc and es-pemfc in the local agent in my country.. and so i try to get from here from you..

and i am a student in the university but at our university it is not used STAR-CD but i want to try it in STAR-CD.. also i have not joined any course of CD-adapco.. because it is not according to my pocket.. what can i do so?

have you any recommendation for me?

The first point to understand is that es.tools are known as expert systems. They make it easy to set up specific model involving a wide range of physics. These tools also contain application specific post-processing capabilities as standard.

Expert system means exactly that, behind the scenes you are expected to be a good user of Star-CD. You will need a Star-CD license to run the model. es.tools are pre / post processors only.

Start by looking at the adapco web page for the location of various offices and agents. Ask about the academic programme run by adapco.

As a student you know how much time you have for this project. Be realistic in what can be achieved because there is a learning curve for Star-CD before you can think about using an es.tool on the back of it.

Do not be afraid of talking to adapco about what is realistic as a student project. Why, because a smaller well done project will get you a better degree than a large project unfinished. In the background adapco will be happy to have a new user going into industry afterwards. Make absolutely sure that the University is aware and your supervisor is involved as well.

Regards

Dear Peter,

I know that what is es-tools.. how can use STAR-CD.. for example last season i used es-ice and have some results and i was happy..

i said that cos I am user of STAR-CD too. but usually i use STAR-CCM+ for my many cases. at home i am using crack license like many users.

ok i will try to contact with cd-adapco for this issue. i hope they will not ignore my request.

thanks for your offers..

Hi everybody..

Now i am studing on fuel cells and i need es-pemfc tutorials and using guides. if anybody has any materials about these please share it with me..

i only try to solve the problem in es-pemfc with default values, but i failed in first time.. without using guide and tutorials it likes impossible to get any accurate results.. and to learn

thanks a lot already..