Scratch Space?

September 14, 2007, 11:32

Can somebody explain what scratch space is?

I am trying to load a pretty complicated .iges file into pro-automesh, and I keep getting an error "Not Enough Scratch Space"

I used the Memory command to increase it from 10E6 to 20E6, but I got the error again (although I made more progress this time).

I'm sure I just need to keep bumping it up, but what is it?

September 17, 2007, 09:46

I think you should try using prosurf or STAR-CCM+ to import the iges.

September 17, 2007, 11:31

Your right. I tried that a little after posting that message. SOOOOO much easier to import a large model. Thanks!

September 14, 2007, 11:32	Scratch Space?	#1
B Bru Guest Posts: n/a	Can somebody explain what scratch space is? I am trying to load a pretty complicated .iges file into pro-automesh, and I keep getting an error "Not Enough Scratch Space" I used the Memory command to increase it from 10E6 to 20E6, but I got the error again (although I made more progress this time). I'm sure I just need to keep bumping it up, but what is it?

September 17, 2007, 09:46	Re: Scratch Space?	#2
redrabbit Guest Posts: n/a	I think you should try using prosurf or STAR-CCM+ to import the iges.

September 17, 2007, 11:31	Re: Scratch Space?	#3
B Bru Guest Posts: n/a	Your right. I tried that a little after posting that message. SOOOOO much easier to import a large model. Thanks!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
RAM and Swap Space and HD space	Anindya	Siemens	2	May 25, 2016 21:40
Scratch Space Error during combustion simulation	Emmanuel Kasseris	Siemens	10	October 25, 2008 17:12
Max Scratch Space	Ravi	Siemens	2	May 18, 2007 01:54
How to compile OpenFOAM from scratch bashrc and cshrc	danieltourde	OpenFOAM Installation	2	December 15, 2006 09:30
HD Space for LES	ANINDYA	Main CFD Forum	4	February 16, 2001 11:56