CFD Online Discussion Forums

CFD Online Discussion Forums (
-   Siemens (
-   -   AMG troubles - help? (

Stephanie September 21, 2007 03:37

AMG troubles - help?
I started a parallel calculation with AMG. After 60 iterations the job is killed. Error message is following:

Process 1 amg_error: amg_trunc : error (1) occurred ierr_amg= 2981 Please contact CD-adapco support. STAR MPI_ABORT executed from processor 1

For an another mesh (same geometry ans settings) the job run until convergence.

What is the problem?

Thanks for your help.

Donald September 22, 2007 14:03

Re: AMG troubles - help?
try CG algorithm. If it works, it means the AMG solver diverges.

All times are GMT -4. The time now is 08:16.