CFD Online Discussion Forums

CFD Online Discussion Forums (
-   Siemens (
-   -   "could not bind to local port" (

Frias December 20, 2007 04:14

"could not bind to local port"
Hi guys,

I try to make an air simulation of an ICE using Star-CD 3.26 and a mesh created with es-ice. When I launch STAR:

"could not bind to local port cannot assign requested address"

and stop the simulation (or better, never start!!!)

Please help me

Many thanks


Vinny December 20, 2007 05:18

Re: "could not bind to local port"
If you work on Linux operating system, probably you have an old process "zombie". Use command "ps -ef", and kill the processes where you read PROSTAR or similar. Bye

Frias December 20, 2007 06:11

Re: "could not bind to local port"
Thanks a lot Vinny,

i 've done what you said but it still didn't work.

what can i do??


Vinny December 20, 2007 06:51

Re: "could not bind to local port"
Mhmhm, try to restart network services and check if rsh is active.

Another try (if you use a workstation) is to restart your pc and suddenly run the calculation. You must be sure you haven't another Ice process. In fact, you can run only one Ice-simulation for each pc. Vinny

Frias December 20, 2007 06:55

Re: "could not bind to local port"
Now there is a big real problem. When i launch star, in the "top" there are no ICE process!!!!


Very very thanks


Frias December 21, 2007 05:05

Now works
It's a license problem (wrong IP)!!

Thanks for your answers


All times are GMT -4. The time now is 23:05.