|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi guys,
I try to make an air simulation of an ICE using Star-CD 3.26 and a mesh created with es-ice. When I launch STAR: "could not bind to local port cannot assign requested address" and stop the simulation (or better, never start!!!) Please help me Many thanks Eddy |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
If you work on Linux operating system, probably you have an old process "zombie". Use command "ps -ef", and kill the processes where you read PROSTAR or similar. Bye
|
|
![]() |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
Thanks a lot Vinny,
i 've done what you said but it still didn't work. what can i do?? Thanks |
|
![]() |
![]() |
![]() |
#4 |
Guest
Posts: n/a
|
Mhmhm, try to restart network services and check if rsh is active.
Another try (if you use a workstation) is to restart your pc and suddenly run the calculation. You must be sure you haven't another Ice process. In fact, you can run only one Ice-simulation for each pc. Vinny |
|
![]() |
![]() |
![]() |
#5 |
Guest
Posts: n/a
|
Now there is a big real problem. When i launch star, in the "top" there are no ICE process!!!!
Why Very very thanks Eddy |
|
![]() |
![]() |
![]() |
#6 |
Guest
Posts: n/a
|
It's a license problem (wrong IP)!!
Thanks for your answers Eddy |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFoam local and local | sven82 | OpenFOAM Installation | 1 | December 9, 2008 10:40 |
Port OpenFOAM to IBM Cell BE | mgarcia | OpenFOAM Installation | 2 | November 1, 2007 08:33 |
Port of OpenFOAM14 to FreeBSD | thierry | OpenFOAM Installation | 0 | April 28, 2007 10:36 |
Suse Linux 91 port | hjasak | OpenFOAM Installation | 23 | April 16, 2006 12:13 |
Linux/Alpha port ? | Prateep Chatterjee | FLUENT | 1 | June 5, 2000 22:28 |