Home > Forums > Software User Forums > Siemens

CCM+ - plane section definition in local COS

Mark Forums Read

Reply

Search this Thread

January 21, 2008, 05:52	CCM+ - plane section definition in local COS	#1
excl Guest Posts: n/a	hello everybody, i need to define several planes for postprocessing in ccm+. the possibility i found installed is awful to use. it would be much easier if i could use some kind of a local COS. can anyone help? regards excl

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Definition of Plane pointer	Julian K.	FLUENT	0	January 5, 2009 11:24
plane section passing through an object	sabry	Siemens	6	July 6, 2008 12:31
Defining Section Plane from Vset	Cb	Siemens	0	March 4, 2005 05:09
user defined plane-definition for postprocessing	Markus	CFX	2	March 13, 2003 05:44
Mixing plane geometry definition	Hbet	FLUENT	0	January 18, 2002 08:16

All times are GMT -4. The time now is 07:33.