Warning 020
Hello, I got the following error message (although the simulation works fine).
*** WARNING #020 *** CELL CENTRE OUTSIDE OF THE CELL FOR CELL NO. 41642 How does this affect my solution or the speed of the run? And how can I fix it? Thank you! Pepe |
Re: Warning 020
That is a concave cell. It's center of mass does not lie within the cell itself. I wouldn't worry too much about it unless you have several of them.
|
Re: Warning 020
You should worry about them, it means the fluxes at this location will be applied somewhere else than this location, and most likely mess up your solution. Imagine a volume so distorted the center is outside the cell.
It is usually called "Elephantman mesh" good luck Polder |
Re: Warning 020
Check the centroid and concave element. If centroid, then it will affect the solution.
|
Re: Warning 020
Well, it's pretty strange. I got this error message with plenty of cells (let's say hundreds), but they all look fine. No immoderate distortion or streching.
Cannot find the source of it.. |
All times are GMT -4. The time now is 17:26. |