post process to get an arbitrary face data
Good day. I want to use post register operation to get data, and I ran a simple case about two metal layer pure conduction. The goal is temperature data distribution in the interface, so I set a shell on the interface.
I clicked the fuction button=> load boundary data => temperature=> got vales in column register 4. My question is.. Can I specify "one" boundary and only get this boundary region data? And after I did steps described above, three another shell appeared in the cell table, symmentry shell, wall shell, nonwall shell, respectively. However, I checked the cell numbers corresponding to register4 in the register list, they are cell numbers of symmentry shell in the cell list. I am very confusing because the three shells does not really exist. How can I get the temperature in the interface ?? |
Re: post process to get an arbitrary face data
bset news regi xxx vset news bset cset news vset all wplo
|
Re: post process to get an arbitrary face data
Thank you so much sir..
I think I got the tip to specify the vertex.. |
All times are GMT -4. The time now is 04:49. |