|
[Sponsors] |
February 29, 2008, 10:51 |
error in cyclic boundaries match
|
#1 |
Guest
Posts: n/a
|
I have problem in making the match of cyclic boundaries.If i select only one cell of a cyclic boundary with the corresponding cell of the other cyclic boundary it makes me the match, but for more than one cells, the next error appears "the following multiple boundaries all share identical locations and will not be mached", any propose what the error about is?
|
|
February 29, 2008, 15:54 |
Re: error in cyclic boundaries match
|
#2 |
Guest
Posts: n/a
|
Your matching tolerance would appear to be too large in CYMATCH or CYARBIT.
Is the model in meters with very small cells? One possible fix is to move it to mm alternatively change the tolerance on the match command. |
|
March 4, 2008, 05:32 |
Re: error in cyclic boundaries match
|
#3 |
Guest
Posts: n/a
|
my problem is in mm, unfortunately it doesnt seem to be a tolerance problem
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
cyclic boundaries | Zealouk | Siemens | 0 | September 17, 2008 12:28 |
cyclic boundaries | gosia stein | Siemens | 5 | June 13, 2007 08:39 |
[Gmsh] Cyclic boundaries | sampaio | OpenFOAM Meshing & Mesh Conversion | 1 | February 7, 2006 14:26 |
cyclic match errors | sankar | Siemens | 3 | December 3, 2004 07:46 |
Cyclic Boundaries -> Match Option -> Arbitrary | Derek | Siemens | 1 | August 4, 2004 23:06 |