|
[Sponsors] |
August 1, 2008, 00:36 |
Evaporation/Condensation in StarCCM?
|
#1 |
Guest
Posts: n/a
|
Hi, I'm currently using starCCM+'s multiphase model to model a thin film of water flowing down a vertical flat plate (with an air/water interface), and have successfully achieved this.
The next step in my project is to add a heat flux through the plate and model the evaporation of the water into the air. Does anyone know if StarCCM is capable of this? I can't find anything in the help function about evaporation from heat transfer, only phase change due to cavitation. If anyone knows anything about this I would greatly appreciate the help! Cheers, Luke T |
|
March 25, 2010, 14:04 |
|
#2 |
Member
Naimish Harpal (MS Aerospace Engr)
Join Date: Jul 2009
Location: Long Beach, CA
Posts: 50
Rep Power: 17 |
If you are using Lagrangian Multiphase model together with evaporation model, then you can define/set your Boundary condition like either Escape/Rebound/Evaporate. Chose 'Evaporate' and set respective parameters.
I hope that it will help you. Cheers! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can Fluent perform evaporation and condensation simulation? | Wei Shao | FLUENT | 25 | December 1, 2017 05:12 |
Water Evaporation and condensation modeling | Linjie | FLUENT | 3 | February 6, 2012 14:08 |
Evaporation and condensation in a tube | Wei Shao | Main CFD Forum | 4 | September 16, 2009 11:19 |
A tutorial for condensation or evaporation | Asghari | FLUENT | 0 | September 29, 2006 23:25 |
evaporation and condensation in the VOF model | Glev | FLUENT | 0 | December 24, 2004 05:55 |