 |
 |
 |
|
|
|
[Sponsors] | ||||
November 24, 2015, 14:59
|
Solid interface
|
#1 |
|
New Member
Nesrine Bouhrira
Join Date: Nov 2015
Posts: 6
Rep Power: 10  |
hi,
my geometry includes a tube with a fluid circulating inside it and a braid of solid around it. So I have solid-solid conduction and solid-fluid conduction. I set up the mesh and the interfaces between the fluid-solid region and solid-solid region with CCM+ but the mesh didn't generate. Does it have a problem with the interfaces ? Is it ok to set up two different meshes ? Thank you. NesrineB |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how the interface between 2 solid regions is treater in chtMultiRegionFoam ? | Cyp | OpenFOAM | 2 | March 15, 2023 05:35 |
| Waterwheel shaped turbine inside a pipe simulation problem | mshahed91 | CFX | 3 | January 10, 2015 11:19 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
| Problem Interface Solid Fluid with wall velocity Solver v12 | hills1 | CFX | 2 | October 12, 2009 05:36 |
| Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |
Linear Mode
