|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
hello, i am trying a test case for premixed combustion with CFM model. i have give proper BCs in term of scalar properties @ inlet as well as I have inititalzed the field properly. But for some reason I keep on getting error message as equivalence ration is zero. where am i suppsoe to define equivalence ratio explicitly? I thought with scalar defination @ inlets it should calculate equivalence ratio. thanks in advance
|
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
i wish get cfm from you. i research student in geotcnical problem
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
combustion model in premixed combustion chamber | wuyu | FLUENT | 9 | February 16, 2018 11:40 |
Sawdust Combustion-Non-premixed Combustion Model | Jessy | FLUENT | 1 | June 19, 2007 11:59 |
pdf combustion model problem | kris | FLUENT | 0 | February 13, 2007 01:03 |
problem about EDC combustion model | Ma Shihu | FLUENT | 1 | January 19, 2005 04:25 |
Non premixed model - combustion validation problem | David | FLUENT | 2 | October 24, 2003 11:06 |