|
[Sponsors] |
September 1, 2008, 11:37 |
posdat user coding
|
#1 |
Guest
Posts: n/a
|
Hi. I want to use a subroutine to print pressure and velocity at the end of the simulation at inlet veticies but don't know how to do that. Does anyone can help me? I have problems with the code.
|
|
September 16, 2008, 18:46 |
Re: posdat user coding
|
#2 |
Guest
Posts: n/a
|
Hi Sara,
Try using 'call FsetBoun' macro in posdat.f, if using v4.06. You can get the inlet boundary faces and obtain pressure and velocity with those face id's. For more info, you can refer to Supplementary Notes. hirokata |
|
September 17, 2008, 17:02 |
Re: posdat user coding
|
#3 |
Guest
Posts: n/a
|
thanks for your answer but I'm using v3.26 and I don't find FsetBoun. Thank you again.
|
|
September 18, 2008, 14:59 |
Re: posdat user coding
|
#4 |
Guest
Posts: n/a
|
Across faces, you can use an internal boundary. After its creation, you can go to 'Monitor Boundary Behavior' and set up a monitor that will export your data per iteration.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
VOF user coding | Ramki | Siemens | 2 | October 29, 2015 02:07 |
converting user-coding in V4 | Karl Mehler | Siemens | 0 | September 28, 2008 16:48 |
Print value to screen in user coding? | Cb | Siemens | 1 | September 30, 2005 08:29 |
plz, help me, CFD coding | sharuk | Main CFD Forum | 0 | April 6, 2005 06:09 |
User coding on NT w2k | Philip Jones | Siemens | 0 | November 26, 2001 04:43 |