|
[Sponsors] |
September 26, 2008, 17:44 |
moving mesh commands
|
#1 |
Guest
Posts: n/a
|
Hi,
I am working on the moving mesh events. After I look the tutorials 13 that is about in cylinder, I have several question. 1. in that scripts there is a command vgen ngen 50 vset what is that for? if I change 50 to 5000, what is it affect ? I don't understand that command. 2. In that script events is defined as 40. why? if I change it to higher, what is happened? If anyone give me help I will appreciate him,her Thanks loockheed |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
moving mesh | sadid | Main CFD Forum | 1 | May 4, 2008 06:33 |
Moving Reference frame - UDF - Moving mesh | modisa | FLUENT | 0 | April 18, 2008 14:31 |
can't run moving mesh!!! | hezheng | Siemens | 0 | July 23, 2005 08:32 |
C4 = 1 for Moving Mesh | Xobile | Siemens | 2 | January 18, 2005 06:22 |
Moving Mesh & Not Rotating Mesh | AB | Siemens | 1 | October 25, 2004 04:10 |