CFD Online Discussion Forums

CFD Online Discussion Forums (
-   Siemens (
-   -   to identify "pressure inlet" in continua (

IKS November 6, 2008 16:06

to identify "pressure inlet" in continua
In the entrance of a rectangular duct carrying low velocity air at 25 C, I tried to identify "pressure inlet" condition under Regions menu. There is no such an option in drop-down menu. Isn't it possible for Star CCM+? Sorry I am a rookie!

Andrea November 7, 2008 04:01

Re: to identify "pressure inlet" in continua
No, there isn't a pressure option for inlet boundary, you're right. Pressure boundary is suggested only for outlet boundary in CCM+, I think it's better to use Stagnation boundary or Mass flow if you know it.

All times are GMT -4. The time now is 18:27.