CFD Online Discussion Forums

CFD Online Discussion Forums (
-   Siemens (
-   -   inner interface (

MAB November 11, 2008 07:01

inner interface
Hi , I have defined two regions while creating geometry and then have imported it into starccm+. I need two define the inner interface where the two regions join each other. both are fluid regions. when i try to convert the face to inner interface it creates a copy as well. now I have one face and one copy in each region all together four where I need only two. any hint please??

MAB November 11, 2008 08:05

Re: inner interface
I am getting the following message when i try to generate volume mesh.

An edge attached to Boundaries: Face 5, device is attached to an odd number of faces (3). Check surface and interface definitions on these boundaries before proceeding.:

Adam November 11, 2008 14:45

Re: inner interface
Delete whatever copies and interfaces you already created.

Select the two interfaces needed (one from each region), do "Create Interface", "In-Place".

"Convert to interface" should be used if you don't have separate regions already set up. Otherwise, use "Create Interface"

All times are GMT -4. The time now is 03:46.