|
[Sponsors] |
December 23, 2008, 05:51 |
No pressure increase with compressing piston
|
#1 |
Guest
Posts: n/a
|
Hi all, I need some help concerning an engine simulation. I have made a simulation from a DI engine, where a slice of a piston has to compress the in-cylinder air. With an event file I've created the moving mesh by removing cell layers. When I use the 'mesh preview run', everything works well and the piston is 'moving'. But when I do a 'normal' run, the air above the piston does not show any pressure or temperature increase.
Does it has something to do with the boundary conditions? The walls of the slice are defined as Wall boundary conds, as well as the piston surface and the cylinder head. I hope someone can help! Erik |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to increase "Newton Pressure Iteration Limit" | kus | CFX | 9 | April 21, 2013 02:54 |
why does the pressure increase in piston case?? | sweetcherry | FLUENT | 2 | June 30, 2008 11:13 |
Total pressure increase in the diverging duct | shiv | Siemens | 3 | February 1, 2008 04:39 |
back pressure of the piston | sachin | Main CFD Forum | 0 | April 7, 2006 03:06 |
Increase of the total pressure ???!!!! | Karim LOUESLATI | Siemens | 3 | December 19, 2001 11:12 |