 |
 |
 |
|
|
|
[Sponsors] | ||||
January 15, 2009, 08:21
|
mass flow rate in STAR CD V3.26
|
#1 |
|
Guest
Posts: n/a
|
Hello I am modeling a combustion chamber in Star CD V3.26. I want to find out the mass flow rate on different planes of the chamber and on symmetry planes. Reply will be appriciated. Regards, Paolo
|
|
|
||
|
January 15, 2009, 11:13
|
Re: mass flow rate in STAR CD V3.26
|
#2 |
|
Guest
Posts: n/a
|
Do a section slice where you want the mass flow. then getc,all,dens$integrate cset. The last column of the output is mass flowrate.
tom |
|
|
|
||
|
January 15, 2009, 14:12
|
Re: mass flow rate in STAR CD V3.26
|
#3 |
|
Guest
Posts: n/a
|
Thank you so much Tom. If you can help me again, I want to find out the swirl number on different planes of the chamber. Is it possible to do in STAR? thanks Paolo
|
|
|
|
||
|
January 15, 2009, 17:36
|
Re: mass flow rate in STAR CD V3.26
|
#4 |
|
Guest
Posts: n/a
|
||
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mass flow rate of the DPM mass sourse ?? | Rhinocao | FLUENT | 3 | January 21, 2011 13:10 |
| Mass flux and mass flow rate | us | Phoenics | 10 | March 31, 2006 03:06 |
| mass flow rate | Dr C.Bhasker | Siemens | 5 | December 20, 2005 05:08 |
| Mass flow rate | Saturn | FLUENT | 0 | September 30, 2004 07:25 |
| How are the mass flux and mass flow rate defined? | Miles | Siemens | 2 | November 7, 2002 09:45 |
Linear Mode
