|
[Sponsors] |
January 27, 2009, 05:28 |
a question about Starccm+
|
#1 |
Guest
Posts: n/a
|
Hallo everyone:
How i can choose one cell, which i want it,in Starccm+ just like in Starcd. I want to watch the cell during the Calculation. Thanks a lot |
|
January 27, 2009, 05:39 |
Re: a question about Starccm+
|
#2 |
Guest
Posts: n/a
|
Under Representations/Volume mesh/Cell sets you can create a cell set and manually select a cell using the zone tool in your scene or if you know the cell number through a cell list. Just as in Prostar you can work with subsets and whatnot.
Good luck |
|
January 27, 2009, 06:20 |
Re: a question about Starccm+
|
#3 |
Guest
Posts: n/a
|
You can also obtain the cells you want to look by a derived part object, using cell number, cell centroid location, etc...
|
|
January 27, 2009, 06:50 |
Re: a question about Starccm+
|
#4 |
Guest
Posts: n/a
|
How can i know the each cell Number?
|
|
January 27, 2009, 12:54 |
Re: a question about Starccm+
|
#5 |
Guest
Posts: n/a
|
I think it is more likely that you just want to monitor a certain point. Monitoring a cell is not how this is done in Star-CCM+. You should use a point probe with a maximum report.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
question about Turbulence Specification in Starccm | Wei | Siemens | 2 | February 2, 2009 05:14 |
help!!(starccm+) | sally | Siemens | 2 | June 26, 2008 21:20 |
VOF in starccm+ | kamal | Siemens | 1 | December 7, 2007 07:54 |
Starccm+ | Ahmed | Siemens | 5 | July 23, 2007 03:21 |
STARCCM+ | tina | Siemens | 2 | May 2, 2006 10:34 |