Informations needed about Moving Wall

AdrienL · August 3, 2011, 06:13

Hi all,

Has anyone information about the moving wall (real displacement) in Star CCm+ because there aren't much information in the Starcc+ Help.

My problem is shonw in the attached picture.

Thanks a lot for all your answer.

Adrien

Maddin · August 5, 2011, 15:25

Read the other topics about this.
Run 5 steps, change mesh, remesh and 5 steps again etc...

AdrienL · August 5, 2011, 17:27

The only way in CCM+ is the remeshing ??? it's was my first idea but it's way to long to remesh every 5 steps ...

ping · August 15, 2011, 21:38

you should use motion type Morphing for this case - very easy - read the help and do the training guide on this subject. You would only need to remesh if the red box gets too close to the blue box.
I suggest you post to the STAR-CCM+ forum in future.

August 5, 2011, 17:27		#3
AdrienL Member Adrien Lemoine Join Date: Jun 2011 Location: Paris,France Posts: 31 Rep Power: 14	The only way in CCM+ is the remeshing ??? it's was my first idea but it's way to long to remesh every 5 steps ... __________________ ------------------------------------------- Plz add reputation if the answer is correct A cœur vaillant rien d'impossible ------------------------------------------

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wall function for DPM needed	AMusteykis	FLUENT	0	January 13, 2010 15:02
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 20:30
moving wall and fluid	soody	FLUENT	3	September 20, 2004 01:37
How to use UDF to define a moving wall	lingo	FLUENT	2	April 23, 2004 02:38
Values of k & epsilon in the moving wall	ghlee	Main CFD Forum	1	August 16, 1999 12:42

August 5, 2011, 15:25		#2
Maddin Senior Member Join Date: Mar 2009 Posts: 260 Rep Power: 18	Read the other topics about this. Run 5 steps, change mesh, remesh and 5 steps again etc...

August 15, 2011, 21:38		#4
ping Senior Member Ping Join Date: Mar 2009 Posts: 556 Rep Power: 20	you should use motion type Morphing for this case - very easy - read the help and do the training guide on this subject. You would only need to remesh if the red box gets too close to the blue box. I suggest you post to the STAR-CCM+ forum in future.