Mesh generation from surface model

wei · April 23, 2009, 11:40

What commands should I used to generate a mesh from surface model and connect the new mesh to the old mesh?

vishyaroon · April 23, 2009, 15:30

You can couple two meshes together using the cpcreate command (to create a couple)

cset news zone (select the mesh in the vicinity of the interface)
cpcreate cset

Is this what you are asking for?

wei · April 24, 2009, 02:33

sorry for a confusing question. I want

1) to create a new mesh from a group of points. Please see http://www.whlam.com/d3.jpg

2) match the new mesh to existing mesh.

April 23, 2009, 11:40	Mesh generation from surface model	#1
wei New Member wei Join Date: Apr 2009 Posts: 17 Rep Power: 16	What commands should I used to generate a mesh from surface model and connect the new mesh to the old mesh?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	18	March 3, 2015 05:36
CAD model sliver faces - CFX Mesh - Parasolid?	Ianto	CFX	3	February 8, 2009 18:32
2D mesh export of an original 3D model	Yogendra Shastri	Main CFD Forum	0	February 22, 2008 13:14
[Technical] Mesh generation from dirty surface meshes	bastil	OpenFOAM Meshing & Mesh Conversion	9	December 10, 2007 11:17
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10

April 23, 2009, 15:30		#2
vishyaroon Senior Member Aroon Join Date: Apr 2009 Location: Racine WI Posts: 148 Rep Power: 17	You can couple two meshes together using the cpcreate command (to create a couple) cset news zone (select the mesh in the vicinity of the interface) cpcreate cset Is this what you are asking for?

April 24, 2009, 02:33		#3
wei New Member wei Join Date: Apr 2009 Posts: 17 Rep Power: 16	sorry for a confusing question. I want 1) to create a new mesh from a group of points. Please see http://www.whlam.com/d3.jpg 2) match the new mesh to existing mesh.