|
[Sponsors] |
June 2, 2009, 15:16 |
Trimming and Mapping Methods with ES-ICE
|
#1 |
New Member
Flavio Zancanaro
Join Date: Apr 2009
Posts: 2
Rep Power: 0 |
Dear People
I’m trying to do a simulation of an ASTM CFR engine using the “Method Mapping (es-ice)” and I am with a lot of difficulty to finish it. When finishing the mapping stage I accomplished the verification of negative volumes in the mesh and the result is zero negative volumes, but when I do the verification for the “Create Result – (es-ice)” appear several negative volumes. Can anybody help me about the method mapping? Another doubt, when I do for the trimming method mistake happens at the moment of cutting the port, because that? I have the geometry of the engine, if you could help me I can send by e-mail. Regards Flavio Zancanaro |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|